UNIPI_S2AI – Patron section 2, analog inputs

Block SymbolLicensing group: UNIPI

Function Description
The UNIPI_S2AI block is used to read the analog inputs located in section 2 of the Unipi Patron device. The block can be used only with specific Patron models that have more than one section. More information can be found on the manufacturer’s website [1].

This block does not propagate the signal quality. More information can be found in the 1.4 section.

Input

HLD	Hold	Bool

Parameter

mode1..mode4

Mode voltage/current $⊙$ 1

Long (I32)

0 ....: Voltage 0 - 10V
1 ....: Current 0 - 20mA

Output

VALID	Data validity indicator	Bool
err_id	Error ID	Long (I32)
AI2_1	Analog input	Double (F64)
AI2_2	Analog input	Double (F64)
AI2_3	Analog input	Double (F64)
AI2_4	Analog input	Double (F64)

[Previous] [Back to top] [Up] [Next]