UNIPI_S2RO – Patron section 2, relay outputs

Block SymbolLicensing group: UNIPI

Function Description
The UNIPI_S2RO block is used to control the relay outputs located in section 2 of the Unipi Patron device. The block can be used only with specific Patron models that have more than one section. More information can be found on the manufacturer’s website [1].

This block does not propagate the signal quality. More information can be found in the 1.4 section.

Input

HLD	Hold	Bool
RO2_1	Digital output	Bool
RO2_2	Digital output	Bool
RO2_3	Digital output	Bool
RO2_4	Digital output	Bool
RO2_5	Digital output	Bool

Parameter

enable_DS1..enable_DS4	Enable direct switch $⊙$ on	Bool
invert_DS1..invert_DS4	Invert direct switch $⊙$ on	Bool
togle_DS1..togle_DS4	Toggle direct switch $⊙$ on	Bool

Output

VALID	Data validity indicator	Bool
err_id	Error ID	Long (I32)

[Previous] [Back to top] [Up]