UNIPI_S1AOR – Patron section 1, analog output or resistance input

Block SymbolLicensing group: UNIPI

Function Description
The UNIPI_S1AOR block allows controlling the analog output located in section 1 of the Unipi Patron device. This section is present in all Unipi Patron models. Depending on the value of the mode parameter, it is possible to generate voltage, current, or measure resistance. More information can be found on the manufacturer’s website [1].

This block does not propagate the signal quality. More information can be found in the 1.4 section.

Input

HLD	Hold	Bool
AOR1_1	Analog output	Bool

Parameter

mode

Mode $⊙$ 1

Long (I32)

0 ....: Voltage output 0 - 10V
1 ....: Current output 0 - 20mA
3 ....: Resistance measurement 0 - 2 k $Ω$

Output

VALID	Data validity indicator	Bool
err_id	Error ID	Long (I32)
AORV	Measured resistance	Double (F64)

[Previous] [Back to top] [Up] [Next]