PARX – Block with input-defined parameter

Block SymbolLicensing group: STANDARD

Function Description
The PARX block, like the PARB, PARI, PARR and PARS blocks, allows changing one of its parameters by changing the input. Unlike the blocks mentioned above, the PARX block parameter can be of any type. The parameter type is set with the type parameter. It is possible to set parameter saturation limits for relevant types.

This block does not propagate the signal quality. More information can be found in the 1.4 section.

Input

p	Parameter value	Any
LOC	Activation of local mode	Bool
	off .. The parameter follows the input on ... Local mode active

Parameter

par	Internal value of parameter $⊙$ 1.0	Double (F64)
SATF	Saturation flag	Bool
	off .. Signal not limited on ... Saturation limits active
hilim	Upper limit of the output signal $⊙$ 1.0	Double (F64)
lolim	Lower limit of the output signal $⊙$ -1.0	Double (F64)
type	Data type of item $⊙$ 8	Byte (U8)
	1 .... Bool 2 .... Byte (U8) 3 .... Short (I16) 4 .... Long (I32) 5 .... Word (U16) 6 .... DWord (U32) 7 .... Float (F32) 8 .... Double (F64) 9 .... Time 10 ... Large (I64) 11 ... Error 12 ... String 13 ... Reference

Output

y	Parameter value	Any

[Previous] [Back to top] [Up] [Next]