CanSend – Send CAN message

Block SymbolLicensing group: CANDRV

Function Description
The CanSend block sends message via CAN bus. The message content is defined by the msgId, data and length inputs and the RTR and EXT parameters. Message is sent only if the input RUN is set to on.

The block must be linked with the CanDrv driver. The driver must be configured to use the simple CAN mode (i.e. the parameter $NodeMode = 256$ ). The block’s name must be in the form <DRV>__<signal> (see e.g. Goto, OUTQUAD or OUTOCT blocks for details about referencing data from I/O drivers). The <signal> part of the name has no special meaning in this case and it is recommended to keep the original CanSend.

The block supports short (11-bit) and long (29-bit) message IDs (see the EXT parameter) and RequestToReceive messages (see the RTR parameter). FD mode which allows up to 64 data bytes in a single message is not supported.

This block does not propagate the signal quality. More information can be found in the 1.4 section.

Input

msgId	CAN message ID (COB-ID) $↓$ 0 $↑$ 536870911	Long (I32)
length	Message length (number of bytes of data) $↓$ 0 $↑$ 8	Long (I32)
data	Message data (8 bytes maximum, LSB first) $↓$ -9.22337E+18 $↑$ 9.22337E+18	Large (I64)
RUN	Sending message is enabled	Bool

Parameter

RTR	Request To Receive flag $⊙$ on	Bool
EXT	Extended message ID (29bits) $⊙$ on	Bool

Output

iErr	Error code	Error

[Previous] [Back to top] [Up]